kaierkki ja VetteMan
Onpas niitä hajonnut. Tossa kun aloin etsimään ohjetta miten jakajan korkeus säädetään niin osui tämä ohje silmiini. Tästä tulee väkisin mieleen, että olisin kiristänyt aivan liikaa tota mutteria mutta kyllä mulla on yleensä ihan hyvä tatsi noihin.
Tässä uudessa MSD85501 jakajassahan on säädettävä korkeus pannan avulla (slip collar). Lähdetäänpäs tallille ihmettelemään miten se nyt sitten oikein säädetään.
Adjusting the slip collar
Before installing the Pro-Billet Distributor, the slip collar adjustment must be set. MSD offers a special
tool, the 3-In-1 Distributor Set Up Tool, PN 8599, to make these adjustments accurately. If the tool is
not available, follow this procedure.
1. Install the gasket to the housing then loosen the slip collar and insert the distributor into the engine
until it bottoms out against the oil pump drive.
2. After it bottoms out, raise the distributor 0.010" - 0.030" then slide the slip collar down into position
and tighten it.
Checking Gear Mesh
It is recommended to check for proper gear mesh between the cam gear and distributor gear. To
do this, coat the distributor gear with moly grease and install the distributor. Next, crank the engine
over several times. Before pulling the distributor out, make sure the rotor is in the position that lines
up with the original removal mark. Then pull the distributor out and inspect the gear pattern shown
on the grease. The proper mesh will leave an even pattern in the middle of the gear. Adjust the slip
collar to obtain the correct mesh.
Checking the Oil Pump to Distributor Shaft Overlap
The proper overlap between the distributor shaft and the oil pump shaft is very important. The tongue of
the distributor shaft should fit into the groove of the oil pump shaft by at least 1/4". To check this:
1. Measure the distance between the base of the slip collar to the tip of the distributor shaft - Figure 8.
2. Using a straight edge, measure the distance from the intake manifold distributor flange to the top
of the oil pump intermediate shaft - Figure 8.
3. Take the two measurements and subtract them. The difference is the overlap. If there is not enough
clearance or too much clearance, a different oil pump intermediate shaft is required.
Figure 8 Measuring Oil Pump Shaft Overlap."